1. Holding your device in landscape mode with the volume control buttons facing up, press the top half of your device into the case and apply light pressure to snap it snuggly into place.
2. Press the bottom half of your device into the case and check each corner to make sure your device is seated properly.
3. Once your device has been inserted into the case, attach the case to the keyboard by setting the case in one of the two cradles on the keyboard (above the keys).
4. Place the top of the magnetized, foldable back flap against the top of the back of the case. You’ll feel it magnetically snap into place. This should create a triangular stand at the base of the flap that props up your tablet in the case.
5. To detach the case from the keyboard, simply pull the magnetized back flap away from the case.
6. To remove your device from the case, hold on to the top lip of the case and press against the back of the case. Then, grasp the exposed side of your device and lift/pull it away from the cover.
REMOVING YOUR DEVICE
1. To detach the case from the keyboard, simply pull the magnetized back flap away from the case.
2. To remove your device from the case, hold on to the top lip of the case and press against the back of the case. Then, grasp the exposed side of your device and lift/pull it away from the cover.
Removing the the tablet in the case from the grooves above the keyboard will disconnect Bluetooth, and the virtual keyboard will appear on the iPad.