INSERTING/REMOVING YOUR TABLET
To insert your tablet into the Rugged Book open the Book’s
case and remove it from the keyboard (to do this pull the case
up and away from the keyboard). Then, line up your tablet with
the holes in the case. Make sure the camera hole is aligned
properly as well as the opening for your charging cable. When
everything is aligned, set the bottom half of your tablet in the
cover and apply light pressure to ensure it’s properly settled.
Snap the top half of your tablet into the cover. Check all
corners to make sure they have seated properly.
When your tablet is secure in the case, you can connect it to
the keyboard by placing it in the magnetic trough. Powerful
magnets will secure it in place, but will also allow you to
remove your tablet any time it benefits you.
To easily remove your tablet from the case, separate the case
from the keyboard, and then gently roll the rubber overmold
away from the edges while pressing the tablet from behind.
Grasp your tablet’s exposed side and lift/pull away from the
Rugged Book.