How Do I Jump Start my Vehicle with the powerstation go charger? – Welcome to ZAGG Care

Jump starting your vehicle with the powerstation go charger

1. Plug the jumper cables into the jump-start output on the powerstation go charger.

NOTE: Make sure the jumper cables are fully plugged into the jump-start output before trying to jump your vehicle.

2. Attach the jumper-cable clamps to the vehicle battery.

- Red clamp on positive terminal (+)

- Black clamp on negative terminal (-)

NOTE: Do not touch red (positive) and black (negative) clamps together at any point. If the jump-start button flashes red, the jumper cables have been connected incorrectly. If this flashing red condition occurs, disconnect the jumper cables from the mophie powerstation go charger and the vehicle battery and restart the process from Step 1.

3. Press the “Jump Start” button and wait for a solid green light.

4. Start your vehicle.

NOTE: The mophie powerstation go charger will allow 3 consecutive jump-start attempts after each time you press the jump-start button. You must allow up to 15 seconds between each jump-start attempt. During the 15 seconds, the jump-start button will flash green while the powerstation go charger performs its safety checks. Once the jump-start button illuminates solid green, the powerstation go charger is ready for the next jump-start attempt. If your vehicle does not start after three attempts, we recommend you consult a certified mechanic.

5. Disconnect the jumper-cable clamps from the car battery.

NOTE: While jump starting your vehicle, you cannot charge your electronic devices using the USB or AC output ports and you cannot charge the powerstation go battery via the AC wall adapter.

Jump start troubleshooting tips