How Do I Install My Mophie Charge Stream Vent Mount?

1. Determine which vent-clip assembly (standard or extended) is needed for proper placement of the vent mount in your vehicle. Attach the vent-clip assembly to the back of the vent mount as shown.

2. Connect the supplied micro-USB cable to the vent mount’s micro-USB port and to the
supplied QC 2.0 car charger’s USB-A port. Insert the car charger into your vehicle’s 12-volt power outlet.

Note: Do not plug the micro USB cable into a vehicle's USB-A port. The vent mount will only work properly when it is powered by the supplied QC 2.0 car charger.

3. Slide the vent clip mounting fingers over one of your vehicle’s vent louvers. (You can rotate the vent clip mounting fingers before installation to accommodate different vent louver thicknesses.)

4. Insert your Qi-enabled smartphone or mophie case with wireless charging into the vent mount. Press the side of the device against the inside of the vent mount’s inner arm (A) and push the device against the charging surface (B). Using the vent mount’s outer arms for leverage will make it easy to insert the device into the vent mount with just one hand.

Was this article helpful?